For use by companies whose certification is covered by INSPEC's UKAS accreditation.
The mark may only be used on company stationery, literature, brochures etc and only in association with the production or service capability covered by a valid certificate and schedule.
The mark shall not be used on vehicles, buildings, flags, calibration certificates, test certificates or similar. Where any doubt about restrictions exists, reference shall be made to INSPEC.
There are no restrictions as to the form of the mark providing it is easily distinguishable and is a faithful reproduction, with a minimum height of 24 mm. However, in exceptional circumstances, a reduction in height is possible, but the mark must remain legible at all times. Exceptional circumstances include space limitation and cost.
The mark shall be produced in a single colour, which should be the predominant ink colour of the document or letterhead.
The company's certificate number shall be applied in direct association with the mark, together with the relevant standard number.
The proportions and form of the mark will be provided at the application stage and are available upon request.
The mark may only be used on stationery where the address is that of the certified site or a qualifying statement is included in the case of general stationery.
If a company wishes to make reference to the quality management system on products or packaging, then the following phrase is permissible "Products manufactured within a quality management system accepted by INSPEC".
If the scope of certification is reduced or cancelled, for whatever reason, company stationery, literature, brochures etc bearing incorrect references and claims shall not be used.
The mark may not be used on, or in direct association with, products, product packaging or similar in such a way that certification by INSPEC of the product(s) themselves may be implied.
Any use of the mark that is unacceptable to INSPEC must cease immediately.