Certification FAQ

What should the Wheel Mark look like?

The Wheel mark must take the form as shown below. 

MarED FAQ

The mark shall be followed by the identification number of the Notified Body which is responsible for the conformity assessment procedure involving the production control phase, (eg modules D or E), and by the last two digits of the number of the year in which the mark is affixed.

If the mark is reduced or enlarged the proportions given in Annex D of the MED must be respected.  The various components of the mark must have substantially the same vertical dimension, which may not be less than 5 mm.  That minimum dimension may be waived for small devices.

 

<< Back